Next in line is the installation of a special rack profile is going on. Using the scissors used in metal work, we carefully cut off the pieces of the necessary length from it. Be sure to take into account that the most optimal length of any rack profile for drywall corresponds to the height of the entire room, minus 10 mm. This distance should be enough for fastening without any possible problems of the entire rack profile directly to the guide profile. The strips of a rack profile used with a certain step should go, which is no more than 600 mm — these are the most minimal requirements to ensure excellent hardness of the entire frame. Its fastening is carried out to the guiding profile through the use of metal screws, and the fastening is necessarily on both sides. As a result of these simple actions, the main frame designed to create a modern partition, has already been assembled from drywall. If you want to make an additional niche from drywall in the wall, it is necessary to think over it in advance, even at the initial stage of creating the future layout of the room. After the full manufacture of the frame itself for the partition from drywall, you can proceed directly to the installation of the sheets of the usual drywall on the prepared frame. Since the drywall sheets are quite heavy, it will require help to install them, one should install drywall sheets on the frame with a high -quality and accurately hardly possible.
