To lay the floor in any room of a residential building, you can use materials of different types. But still, for the most part, the material for the arrangement of the base of the floor is wood. The floor from the boards has certain advantages, due to which it is possible to achieve a good effect when using it. But still there is such a problem as the danger of too fast the wear of such a flooring. Therefore, you have to replace the boards. One of the problems that arise in this case is too much the thickness of the boards. Most often, the hosts try to use materials of such length, thanks to which they manage to immediately lay the floor. That is, in certain cases, the board may have, including 6 meters in length. This primarily applies to those cases when the so -called massive board is used. Yes, it is quite clumsy, but its strength is huge. It is also necessary to understand that the floor of wood, like any other, should have a sufficiently serious strength. It will be possible to provide it only on condition that a board of large thickness is used. And this significantly increases the mass of material. As a result, you have to spend a lot of effort to cover the floor. The board is impressive in length and at the same time has a large thickness… As a result, its mass can be regarded as incredibly huge. But in this case, in this case, the significant strength of the floor will still not be possible to ensure the significant strength of the floor. In order not to have to replace the floor too often, you should first perform a certain processing of the boards. In order for it to be high -quality, you need to understand the properties of wood, as well as the consequences of a certain load of it. In particular, when the wood is recently cut off, it has too impressive moisture absorption. Then you have to immediately after the completion of the laying of the coating of this material with a primer or olifa. But so that the floor from wood serves for a long time, it is also very important to ensure its safety and protection from harmful factors. And for this, you periodically have to perform certain actions to update the boards. Usually the grinding acts as such. At the expense of it, the served layer of wood removes, and the likelihood of any fungal or putrefactive formations is reduced. And this generally increases the durability of the tree.
